Water Skiing

How much horsepower is needed to pull a water skier?

How much horsepower you need to pull a water skier depends on boat weight, load and the skier. See rough ballparks, speeds, and how to improve your boat's pull.

On this page
  1. The Short Answer
  2. Why There’s No Single Number
  3. Rough Horsepower Ballparks
  4. What Speed Does the Skier Need?
  5. Signs Your Boat Doesn’t Have Enough Power
  6. How to Get More Pull From the Boat You Have
  7. Never Exceed the Capacity Plate
  8. Pontoons, Jet Boats and Personal Watercraft
  9. What About Wakeboarding?

The Short Answer

There’s no single horsepower figure that guarantees a boat can pull a water skier. What matters is whether the boat has enough power for its weight and load to get on plane quickly and pull the skier out of the water, then hold a steady speed.

As a very rough guide, boaters commonly find that a light boat with a modest outboard can pull a child on two skis, a typical small runabout with something like 75 to 115 horsepower can usually pull an average adult on two skis, and heavier boats, fuller loads, heavier skiers and slalom skiing call for more. Treat those as ballpark figures, not specifications; a heavy boat with a big engine can still struggle, and a light boat with a smaller one can do surprisingly well.

Why There’s No Single Number

Several factors decide whether a boat can pull a skier:

  • Boat weight. The heavier the boat, the more power it needs to climb onto plane. This is the biggest factor.
  • Passengers and gear. A boat that pulls a skier easily with two people aboard may struggle with six people, a full fuel tank and a cooler.
  • Hull design. Planing hulls built for tow sports get up quickly. Displacement hulls, such as most sailboats, can’t reach skiing speeds no matter how much power you add.
  • The skier. A heavier skier needs more pull to get up. So does a skier on one ski compared with two.
  • Ski size. Bigger skis have more surface area and come up on top of the water at lower speeds.
  • Propeller and setup. The prop’s pitch and the engine’s trim affect how quickly the boat accelerates out of the hole.
  • Altitude and conditions. Engines produce less power at high altitude, and wind and chop add resistance.

That’s why the same engine can be plenty on one boat and not enough on another. Power-to-weight ratio is a more useful way to think about it than horsepower alone.

Rough Horsepower Ballparks

These are general ranges boaters often report, assuming a planing hull and a moderate load. Your boat may do better or worse.

Situation Rough horsepower ballpark
Small child on trainer skis, light boat Often around 40–60 hp
Average adult on two skis, light 15–17 ft runabout Often around 75–115 hp
Adult slalom skier, or a heavier skier Often 115–150 hp or more
Larger or heavier boats (around 20 ft and up, pontoons) Commonly 150 hp or more

Dedicated tournament ski boats typically have inboard engines with several hundred horsepower. That’s more than strictly necessary to pull a recreational skier; the extra power lets them pull skiers out hard and hold exact speeds with consistent results.

What Speed Does the Skier Need?

Horsepower only matters because the boat has to reach and hold the right speed. Common starting points:

Skier Typical speed
Small child on trainer skis About 13–16 mph
Adult on two skis Roughly 20–26 mph
Recreational slalom (one ski) Roughly 26–34 mph
Barefoot skiing Often 35–45 mph, depending on weight

A boat needs enough power to get the skier up quickly and reach these speeds with a margin to spare, not just barely. For details on starting kids, see how to teach a kid to water ski. Barefooting needs significantly more speed and power; our guide to barefoot water skiing covers why.

Signs Your Boat Doesn’t Have Enough Power

  • The boat takes a long time to get on plane with the skier attached, and the bow stays high.
  • The skier gets dragged through the water instead of popping up.
  • The engine is at or near full throttle just to hold skiing speed.
  • Speed drops noticeably when the skier cuts outside the wake.
  • Slalom skiers can’t get up at all, even though two-ski skiers can.

Dragging a skier for a long time is tiring and increases the chance of a fall. If this keeps happening, the setup needs adjusting.

How to Get More Pull From the Boat You Have

Before upgrading the engine, try these:

  • Lighten the load. Fewer passengers and less gear make a big difference. Keep weight centered or slightly forward.
  • Trim the engine down for the start (on outboards and sterndrives) to help the bow come down and the boat get on plane faster.
  • Consider a lower-pitch propeller. A lower pitch generally improves acceleration at the cost of some top speed. A marine dealer can help you choose.
  • Use bigger skis, especially for adults and beginners. Combo skis get up more easily than a slalom ski.
  • Learn on two skis first before trying a one-ski start.
  • Keep the engine and hull in good condition. A fouled hull or poorly running engine costs performance.

Never Exceed the Capacity Plate

If your boat has a capacity plate, it lists the maximum horsepower the hull is rated for, along with maximum persons and load. In the US, most monohull boats under 20 feet are required to carry one. Never install an engine larger than the plate allows; overpowering a hull can make it dangerous to handle and may also cause insurance and legal problems.

Pontoons, Jet Boats and Personal Watercraft

  • Pontoons. Many two-tube pontoons with smaller engines struggle to pull adult skiers. Three-tube pontoons (tritoons) with larger outboards are much more capable and are commonly used for skiing and tubing.
  • Jet boats. Jet-drive boats can pull skiers well when they have enough power for their size.
  • Personal watercraft. Many modern three-seat PWCs have plenty of power for towing skiers. Our article on whether you can water ski on a jet ski covers the rules and tips.

What About Wakeboarding?

Wakeboarders typically ride at lower speeds than skiers, often around 16 to 24 mph, so in principle they need less power to pull. However, dedicated wake boats are heavy and often carry extra ballast to make a bigger wake, so they use large engines anyway. On a regular boat, a setup that can pull an adult skier will usually pull a wakeboarder too. For how the two sports compare, see water skiing vs wakeboarding.

For everything else you need to get started, from crew to the deep-water start, see our guide to how to water ski behind a boat.

The complete guide to water skiing

How to Water Ski Behind a Boat
Read the guide

Keep exploring

Guides from other topics

All topics →