Water Skiing

Water Skiing Hand Signals Every Skier and Driver Should Know

The standard water skiing hand signals for faster, slower, turn, stop, cut motor, back to dock and skier OK, plus the observer's role and skier-down flags.

On this page
  1. Why Hand Signals Matter
  2. Agree on Signals Before You Start
  3. The Standard Water Skiing Hand Signals
  4. Signals After a Fall
  5. The Observer’s Role
  6. Skier-Down Flags
  7. Tips for Clear Signaling

Why Hand Signals Matter

Once a skier is behind the boat, nobody can hear anybody. The engine is loud, the skier is 75 feet back, and the wind carries voices away. Hand signals are how the skier tells the boat what they need, whether that’s a little more speed, a turn, or “take me back to the dock.”

Clear signals make skiing safer and more fun. They prevent the driver from guessing, and they let the observer react quickly when something goes wrong.

Agree on Signals Before You Start

Signals are only useful if everyone understands them the same way. Before the skier gets in the water:

  • Go over every signal with the skier, driver and observer.
  • Demonstrate them so everyone recognizes them from a distance.
  • Agree on anything nonstandard, such as a signal for “tighter turns” or “one more run.”
  • Make sure new skiers know the “I’m OK” signal for after a fall.

The signals below are widely used and appear in many US state boating handbooks, but groups sometimes vary them. What matters most is that your crew agrees.

The Standard Water Skiing Hand Signals

Signal Meaning How to do it
Faster Speed up Thumb pointing up
Slower Slow down Thumb pointing down
Speed OK Current speed is good Thumb and forefinger forming a circle (the “OK” sign)
Turn right Turn the boat to the right Arm out, pointing right
Turn left Turn the boat to the left Arm out, pointing left
Turn around Turn the boat around Arm raised, finger circling overhead
Stop Stop the boat Hand raised, palm facing forward, like a traffic stop
Cut motor Stop immediately, cut the engine Hand or finger drawn across the throat
Back to dock Return to the dock or shore Pat the top of the head
Skier OK I’m OK (after a fall) Hands clasped together over the head
Pick me up / fallen skier I’m here, come get me Hold one ski up out of the water, or raise an arm

Skiers holding the handle with both hands can let go with one hand briefly to signal. On a slalom ski, many skiers keep signals short and simple so they don’t lose balance.

Signals After a Fall

The moments after a fall are when signals matter most:

  1. Let go of the handle and come to the surface.
  2. Give the “Skier OK” signal, hands clasped over your head, as soon as you can. This tells the boat you’re not hurt.
  3. Raise a ski or an arm so the boat can spot you easily, especially in choppy water or busy areas.
  4. Stay where you are and let the boat come to you.

If a skier doesn’t signal that they’re OK, the boat should return immediately and assume they may need help.

The Observer’s Role

The observer (or spotter) sits facing backward and watches the skier at all times. Their job is to:

  • Relay every signal to the driver, who needs to keep their eyes ahead.
  • Tell the driver immediately when the skier falls.
  • Keep the skier in sight while the boat turns back.
  • Display a skier-down flag where required.
  • Watch for loose rope in the water and warn the driver.

Many US states legally require an observer in addition to the driver when towing a skier, and some set a minimum age for the observer. Some states allow a wide-angle rear-view mirror in place of an observer on some boats. Rules vary, so check local boating laws. Even where it isn’t required, an observer is strongly recommended.

Skier-Down Flags

A skier-down flag is typically a bright orange or red flag that the observer holds up to warn other boaters that a skier is in the water, about to start, or that a rope is out. Some states require it in specific situations; check your local rules. Even where it’s optional, it’s a simple way to keep other boats away from a skier in the water.

Tips for Clear Signaling

  • Make signals big and deliberate. Small finger movements are hard to see from 75 feet away.
  • Hold the signal for a moment until the observer acknowledges it, often with a thumbs-up or nod.
  • Repeat it if the boat doesn’t respond.
  • Only give one signal at a time.
  • Keep the same signals all day, even when switching skiers or drivers.

Signals apply whether you’re towing behind a boat or a PWC; see can you water ski on a jet ski for PWC-specific rules. When teaching children, practice the signals on land first, as described in how to teach a kid to water ski. Adaptive programs sometimes adjust signals to suit a skier’s abilities; see adaptive water skiing equipment. For the rest of the fundamentals, see our guide to how to water ski behind a boat.

The complete guide to water skiing

How to Water Ski Behind a Boat
Read the guide

Keep exploring

Guides from other topics

All topics →

How Wake Boats Work

How wake boats turn weight, hull shape, speed and surf systems into rideable wakes and waves, plus a plain-English tour of the parts of a wakeboard boat.