Wake Boat Basics

Wake Boat Propellers vs Jet Drives

Do wake boats have propellers? How inboard props and jet drives compare for wakeboarding and wakesurfing, plus prop pitch, damage and rider safety.

On this page
  1. Do wake boats have propellers?
  2. Where the prop sits and why it matters
  3. Wake boat propellers
  4. How a jet drive works
  5. Wakeboarding behind a jet boat
  6. Forward drives, sterndrives and outboards
  7. Comparison table
  8. Propeller safety around riders

Yes, the great majority of wake boats have a propeller. A typical wake boat is an inboard, with a single propeller on a shaft under the hull, a rudder right behind it, and the swim platform several feet further back. The main alternative is the jet boat, which uses an enclosed impeller instead of an open propeller. Here’s how the two compare for wakeboarding and wakesurfing, and what owners should know about their props.

Do wake boats have propellers?

Dedicated wake boats from the major towboat brands are almost all inboards, most of them V-drives. The engine drives a shaft that passes through the bottom of the hull to a propeller tucked underneath the boat. You can’t see it from the swim platform, but it’s there.

A smaller group of towing boats use other propulsion:

  • Jet boats (for example, Yamaha’s wake-oriented models) use an impeller inside a housing. There’s no exposed propeller.
  • Forward-drive sterndrives use forward-facing propellers mounted under the boat.
  • Sterndrives and outboards on runabouts and pontoons put the propeller at the transom.

Where the prop sits and why it matters

Prop location is the key safety difference between boat types for wake sports:

  • On an inboard, the prop is under the hull, forward of the transom. A wakesurfer riding behind the boat is well clear of it.
  • On a sterndrive or outboard, the prop is at or behind the transom, close to where a wakesurfer rides and where people climb aboard. That’s why boat builders, engine makers and safety groups say not to wakesurf behind them.

An under-hull prop is safer, not safe. A person near the stern of an inboard can still be pulled toward a spinning propeller. Turn the engine off, not just into neutral, whenever someone is boarding, in the water at the stern, or swimming near the boat.

Wake boat propellers

Blades, materials and pitch

Wake boat propellers are typically four-blade designs made from bronze alloys (often nickel-aluminum-bronze) or stainless steel. Four blades help a heavy, ballasted boat get out of the hole and hold a steady speed while pushing a lot of water.

Two numbers describe a prop: diameter and pitch. Pitch is how far the prop would move forward in one revolution if there were no slip. Lower pitch generally gives stronger acceleration and pulling power at the expense of top speed. Higher pitch does the reverse. Builders choose a prop to match the engine, gearbox ratio and typical load. Some owners change props for heavier surf setups, or for high-altitude lakes where engines make less power. Prop changes are best discussed with a dealer or prop shop, since the wrong prop can over-rev or lug the engine.

Can you drive with a damaged prop?

Sometimes you can limp back to the dock slowly, but it isn’t a good idea to keep running on one. A bent or chipped blade unbalances the prop. The resulting vibration stresses the shaft, the strut, the cutless bearing, the shaft seal and the transmission. Typical signs:

  • New vibration, especially at certain speeds
  • Engine revving higher than usual for the same speed (slipping)
  • Weaker acceleration or difficulty holding speed with ballast

If you hit something, have the prop, shaft and strut inspected before your next session. Props can often be repaired by a prop shop. Many owners also carry a spare.

How a jet drive works

A jet boat draws water through an intake grate on the bottom of the hull. An impeller inside a tube accelerates that water and blasts it out of a nozzle at the stern. The thrust pushes the boat forward, and the boat steers by turning the nozzle. Because the impeller is enclosed inside the hull, there’s no propeller hanging below the boat.

Wakeboarding behind a jet boat

Advantages

  • No exposed prop, which many families find reassuring around swimmers and when people climb on and off.
  • Shallow draft, handy at shallow ramps, sandbars and in rivers.
  • Lower purchase price than many comparable inboard wake boats, new or used.
  • Wake features available. Some jet models come with towers, ballast and wake-enhancing hardware, and they pull wakeboarders, skiers and tubes well.

Limitations

  • Smaller wakes. Jet boats are generally lighter, and even with added ballast they typically don’t match a heavily loaded inboard wake boat’s wake or surf wave.
  • Steering depends on thrust. A traditional jet boat has limited steering when you’re off the throttle, which takes some getting used to around docks and when picking up a fallen rider. Some manufacturers have added features to improve low-speed control.
  • Intake debris. Weeds, sticks and ropes can clog the intake grate or the impeller. Keep tow ropes well clear of the stern when idling near a rider in the water. Some boats have systems to help clear intakes.
  • Wakesurfing. There’s no prop, but whether wakesurfing is approved behind a specific jet model is a manufacturer question. Check the owner’s manual rather than assuming.

Forward drives, sterndrives and outboards

  • Forward drive (Volvo Penta): a sterndrive with forward-facing propellers positioned under the boat rather than behind it. It’s marketed as suitable for wakesurfing on boats designed for it.
  • Conventional sterndrive: good for skiing, tubing and general boating, and wakeboarding is common. Not for wakesurfing.
  • Outboard: same as sterndrive. The prop is behind the transom and wakesurfing isn’t safe.

For the inboard layouts themselves, see V-drive vs direct drive inboards.

Comparison table

Inboard (V-drive / direct) Jet drive Forward-drive sterndrive Sterndrive / outboard
Prop location Under hull No exposed prop Under boat, facing forward At transom
Wake size potential Largest Moderate Moderate to large Small to moderate
Wakesurfing Yes (designed for it) Check manufacturer Yes, per manufacturer No
Shallow water Fixed running gear, deeper draft Very shallow Drive tilts Drive / motor tilts
Low-speed steering Rudder, prop walk Thrust-dependent Drive steers Drive / motor steers

Propeller safety around riders

Whatever you drive:

  • Shut the engine off before anyone boards or approaches the stern.
  • Use the engine cut-off switch (lanyard or wireless) while underway.
  • Approach a fallen rider slowly and keep them on the driver’s side, where you can see them.
  • Never let anyone hang on or sit on the swim platform while the engine is running. Exhaust carbon monoxide builds up at the stern.
  • Keep ropes reeled in or held when idling near a rider so they can’t reach the prop or intake.

To see how the drive fits into the rest of the boat, read how wake boats work.

The complete guide to wake boat basics

How Wake Boats Work
Read the guide

Keep exploring

Guides from other topics

All topics →