The Driver’s Job in One Sentence
Give the rider a smooth start, a steady speed and a predictable path, and keep everyone, especially the person in the water, away from danger. Good tow driving is mostly about consistency. Riders notice small changes in speed or direction far more than you’d expect.
Before You Pull Anyone
Pre-Tow Checklist
- Attach the engine cut-off switch (ECOS) lanyard to yourself, or pair a wireless cut-off device.
- Life jackets on the rider, and accessible for everyone else.
- Observer on board. It’s a legal requirement in many places; see do you need a spotter to water ski?.
- Seat, wheel and mirror adjusted so you can see ahead clearly. The observer watches behind.
- Rope attached to a proper tow point and checked for wear, with no loops or tangles near feet or the prop.
- Ski flag ready if required in your area. See ski flag rules.
- Water checked for traffic, swimmers, shallows and obstacles along your intended route.
Agree on Hand Signals
Run through signals before the rider gets in the water (our water skiing hand signals guide covers more):
| Signal | Meaning |
|---|---|
| Thumb up | Faster |
| Thumb down | Slower |
| OK sign or flat hand wave | Speed is good |
| Finger drawn across throat | Stop / cut engine |
| Pointing | Turn this way |
| Hand patting top of head | Done, head back |
| Hands clasped over head after a fall | I’m OK |
Boaters often call directions as port (left) and starboard (right). Here’s how to remember port and starboard.
The Start
Taking Up Slack
With the rider in position and the rope out, idle forward slowly to take up the slack. On boats that idle quickly, you may need to shift in and out of gear. Don’t drag the rider across the water before they’re ready. When the rope is tight and the rider calls “hit it” (or signals), accelerate.
Pulling Up a Wakeboarder vs a Skier
- Wakeboarders come up best with a firm, progressive pull. Too much throttle at once tends to pull a beginner over the front of the board. Too little leaves them plowing water.
- Two-skiers generally want a more decisive pull to get the skis up and on plane quickly.
- Slalom skiers often want a strong, deliberate pull. Ask experienced skiers how they like it.
Whatever the sport, don’t hesitate or back off mid-start. That’s usually what makes a start fail.
Holding Speed and Line
Typical Speed Ranges
Treat these as starting points (see boat speed for wakeboarding for more detail). Rider weight, skill and preference vary a lot, and the rider always has the final say:
- Beginner wakeboarders: often somewhere in the mid to high teens (mph); kids slower.
- Experienced wakeboarders: commonly around 18–24 mph.
- Adults on two skis: often in the low to mid 20s mph; kids considerably slower.
- Slalom: generally faster than two skis, with competition speeds into the 30s mph.
- Wakesurfing: much slower, typically around 9–12 mph.
If your boat has cruise control or a speed control system, use it. Otherwise, pick a speedometer or GPS reading and hold it.
Straight Lines, Wide Turns
- Run long, straight lines in open water. Riders can’t settle into a rhythm if you wander.
- Plan turns well ahead and make them gradual. In a turn, the rider swings outside the boat’s track, speeds up and can hit slack rope.
- Tell the rider before you turn, so they can move to the inside of the wake or prepare.
- Leave generous space from shorelines, docks, buoys and other boats on the outside of the turn.
Crossing Chop and Other Boats’ Wakes
When another boat’s wake is coming, slow down slightly and cross it at an angle rather than head-on or parallel. That keeps the boat level and the rope tension steady. In general chop, holding a consistent moderate speed is better than speeding up and slowing down. If the water gets too rough to ride, call it.
When the Rider Falls
- Your observer calls the fall. Ease off the throttle smoothly; don’t slam it into idle.
- Raise the ski flag if required.
- Turn back toward the rider, keeping them in sight. Turning toward the driver’s side makes them easier to watch.
- Watch for the rider’s “I’m OK” signal. If you don’t see it, go back immediately.
Picking the Rider Up
- Approach slowly, at idle or close to it, with the rider on the driver’s side so you can see them.
- Shift to neutral well before reaching them, and let the boat drift the last few feet.
- Turn the engine off before the rider comes near the stern or swim platform, or at minimum make sure it’s in neutral and they stay clear of the prop.
- Keep the rope out of the water near the propeller. Pull it in or keep it on the opposite side.
The Circle of Death and the Engine Cut-Off Switch
The “circle of death” describes what can happen when an operator is thrown out of a moving boat. With the wheel turned, the unmanned boat circles back, often toward the person in the water. The engine cut-off switch prevents it: if the operator goes overboard, the lanyard pulls the switch and the engine stops.
In the US, federal law requires operators of most recreational boats under 26 feet that have a cut-off switch installed to use it while operating on plane or above displacement speed. Towing usually means you’re on plane, so wear it.
Common Driver Mistakes
- Inconsistent speed. It’s the most common complaint from riders.
- Sharp turns that whip riders or create slack.
- Hesitating on the start.
- Watching the rider instead of the water ahead. That’s the observer’s job.
- Approaching a fallen rider too fast or with the prop turning.
- Leaving the rope in the water during pickups.
For a broader look at towing setups, see our guide to water sports behind a boat. For tube-specific driving, read how fast to pull a tube behind a boat.