Short Answer
Only very briefly. A Sea-Doo Spark isn’t designed to run out of the water except for short checks and during the flushing procedure in the owner’s manual. A rule of thumb often repeated among owners and technicians is to keep any dry run to roughly 15–20 seconds or less. Your operator’s guide is the authority, so check what it says for your model year and follow that.
Why Running Dry Is a Problem on a Spark
Closed-Loop Engine Cooling vs Water-Cooled Exhaust
Many people assume the Spark is safe to run dry because its engine uses a closed-loop cooling system, with coolant circulating through a heat exchanger like a car’s. The engine block is protected that way, but the exhaust system is cooled by water picked up from the jet pump while the craft is moving or idling in the water. Out of the water, no water reaches the exhaust. Exhaust parts, including rubber hoses and plastic components, can overheat quickly.
The Jet Pump and Seals
The jet pump and driveline seals also rely on water for cooling and lubrication. Running dry adds heat and wear to components that are expensive to replace.
When You’d Run It Out of Water
- A quick start check after winter storage or maintenance, a few seconds at idle.
- Flushing after salt, brackish or dirty water, using the garden-hose connection and the order the manual gives.
- Clearing water from the exhaust after flushing. The manual may call for a brief throttle blip.
There’s no need to idle a Spark on the trailer for any length of time, for example to “warm it up”.
How to Flush a Spark Safely
Sea-Doo’s flushing procedure generally follows this order. Confirm it against your own guide:
- Connect a garden hose to the flush connector, without turning the water on.
- Start the engine.
- Turn the water on promptly after the engine starts.
- Let it run at idle for the time the manual specifies.
- Turn the water off.
- Briefly rev the engine if the manual says to, to clear water from the exhaust.
- Stop the engine.
The order matters. Running water into the system while the engine is off can push water back through the exhaust into the engine, which can cause serious damage. Water on, engine running; water off, then engine off.
Signs You Ran It Too Long
- A hot, plastic or burning smell from the exhaust area
- Visibly discoloured or deformed exhaust hoses or parts
- New exhaust leaks or unusual noises next time you ride
If you suspect overheating, have a dealer or qualified technician inspect the exhaust system before riding.
Bottom Line
Treat dry running as a few seconds at most, and flush only with the engine running and the water on in the right order. If you use your Spark to tow, it’s also worth reading wakeboarding behind a jet ski or Sea-Doo. Most Spark models are lighter and less powerful than three-seat tow-sports models, so check that yours is rated for the operator, an observer and a rider before towing.