How Long Should a Tube Tow Rope Be?
Most tube tow ropes are 50–65 feet long, and 60 feet is a very common length. That keeps riders far enough back to stay clear of the boat, its exhaust and the roughest water directly behind the motor, while keeping them visible to the driver and observer.
Some PWC and jet-boat owners prefer a slightly longer rope, around 70–75 feet, to keep riders out of the jet’s spray. Ropes much shorter than 50 feet put riders close to the boat and generally aren’t recommended for standard tubing.
Why Not Just Use a Ski or Wakeboard Rope?
Tube ropes are built for a different load:
- Higher strength. A multi-rider tube creates far more drag than a single skier, especially when it bounces or swings in a turn.
- Rated by number of riders. Tube ropes are typically labelled for a maximum number of riders or a total weight.
- No handle. The rope connects tube to boat; riders hold the tube’s own handles.
Ski and wakeboard ropes aren’t designed for tube loads. Use a rope made for tubes.
Strength Ratings and Rider Count
Tube ropes are usually sold by the number of riders they’re rated for, with a breaking strength printed on the packaging or tag. Industry standards for watersports ropes tie these ratings to rider counts. The simple rule:
- Match or exceed the tube’s maximum rider count with your rope’s rating.
- Use a higher-rated rope if you’re unsure, or if you have heavier riders.
Don’t try to work out loads yourself. Use the rating on the label.
Attaching the Rope to the Boat
Always tow from a point designed for towing. Never use cleats, rails, fences or ladders. See water ski tow bars, pylons and booms for the full rundown.
Ski Pylon or Tow Bar
If your boat has a pylon or stern tow bar, check that it’s rated for tube loads. Some tow points aren’t intended for large multi-rider tubes.
Transom Eyes With a Tow Harness
A tow harness (or bridle) is a short Y-shaped rope that clips to both transom eyes. Many have a floating pulley in the centre. The tube rope attaches to the centre point. The harness spreads the load between both eyes and helps centre the pull. Make sure it’s long enough that the rope stays clear of the motor.
PWC Tow Hook
On a personal watercraft, use the designated tow hook at the stern. See wakeboarding behind a jet ski or Sea-Doo for PWC towing rules.
Attaching the Rope to the Tube
Tubes have a tow point, usually a strong strap or a metal or plastic connector at the front. Many tube ropes include a quick-connect fitting at one end. Some riders also use a “tube rope extender” or a short floating section to keep the connection off the water.
- Connect firmly, and double-check before every run.
- If the tube’s tow point shows wear, such as fraying, stitching coming loose or a cracked connector, stop using it until it’s repaired.
Inspecting and Replacing a Tube Rope
Before each outing, run the rope through your hands and look for:
- Fraying, cuts or flat spots
- Faded or stiff sections from sun exposure
- Damaged or corroded fittings
- Knots, which reduce rope strength and are hard to remove
Replace the rope if you find damage. Sun and wear weaken rope over time, so many owners replace tube ropes every few seasons even if they look fine. After each use, rinse the rope, especially after salt water, let it dry, and store it out of the sun.
Handling the Rope Safely
- Keep the slack rope away from the propeller during starts and pickups.
- Never wrap the rope around hands, arms or anything else.
- Take up slack gently before accelerating.
- Pull the rope in or keep it clear when the boat is idling near swimmers.
For safe tubing speeds, see how fast to pull a tube behind a boat. For general towing technique, see how to drive a boat for wakeboarding and skiing.