Before you go: research and paperwork
- Research the model and year. Find out the engine options and whether the boat has factory ballast and a surf system. Also check whether older model years used wood in the stringers or transom. Owner forums are often helpful.
- Check the title and HIN. The hull identification number on the transom should match the title and registration. Ask whether there’s a lien.
- Ask for records of service, winterization and repairs before you travel.
- Ask about hours and how the boat has been used. See wake boat engine hours: how many is too many.
What to bring
- A bright flashlight
- A notepad or phone for photos and notes
- Paper towels or rags for checking fluids
- A small mirror for hard-to-see areas
- A friend, ideally someone who knows boats
- This checklist
Hull and structure
- Walk around the hull in good light. Look for cracks, star cracks, blisters, deep gouges or poor-quality repairs.
- Check the gelcoat for fading and crazing (fine cracks), especially around the tower mounts and swim platform brackets.
- Stand and bounce gently on the floor, deck and swim platform. Soft spots can point to water damage beneath.
- Inspect the transom, inside and out, for cracks or movement.
- On older boats, ask whether the stringers and transom are composite or wood. Wood rot is a costly repair.
- Look in the bilge for standing water, oil or debris.
Engine (inboard)
- Check that the engine starts cold. Ask the seller not to run it before you arrive.
- Engine oil: check level and condition. Milky or tan oil can indicate water intrusion and is a serious warning sign.
- Look for leaks of oil, coolant or fuel, and for corrosion or rust on the block, manifolds and fittings.
- Check belts, hoses and wiring for cracks, chafing or amateur modifications.
- Ask when the raw-water impeller was last replaced.
- On older engines, ask about exhaust manifolds and risers, which wear over time.
- On many fuel-injected engines, a dealer can read the engine computer for stored hours and fault codes. It’s worth asking for.
- If you’re seriously interested, a compression test (and ideally a leak-down test) by a technician gives a useful baseline. Consistent readings across cylinders matter more than any single number.
Drivetrain: transmission, V-drive, shaft, prop
- Transmission fluid and, on V-drives, V-drive fluid: check level and look for milky or burnt fluid.
- Shaft seal or packing gland: a traditional packing gland normally drips slightly when running. Dripping at rest, or heavy leaking, needs attention. Some boats use dripless seals.
- Prop: look for dings, bends or missing chunks.
- Shaft, strut and rudder: check for play, bends and corrosion.
- Listen for clunks or grinding when shifting during the sea trial.
Ballast system
- Run every ballast pump, both fill and drain, and confirm each tank or bag fills and empties as it should.
- Listen for pumps that struggle or don’t run.
- Check hoses, fittings and bags for leaks, cracks or mildew.
- Ask whether any aftermarket ballast has been added, and how it’s plumbed and secured.
- Remember that heavy ballast over many seasons adds stress. Pay extra attention to the hull and floor on heavily surfed boats.
Surf system and wake plate
- Operate the surf tabs, gates or wedge from the helm and confirm they move fully in both directions.
- Watch for slow, noisy or uneven actuators.
- During the sea trial, switch the surf wave left and right and check the wave forms properly on each side.
Tower, electronics and helm
- Check tower bolts, welds and mounts for cracks or corrosion, and that folding mechanisms work.
- Test the helm display, gauges, speed control, lights, horn, bilge pump and blower.
- Test the stereo and tower speakers. They’re expensive to replace.
- Check the steering for excessive play or stiffness.
Interior and upholstery
- Look for tears, cracking, mildew and stained or brittle vinyl.
- Check seat bases and hinges for rot or broken hardware.
- Look at carpet or mats and underneath them for signs of standing water.
- Interior condition often reflects how the boat was stored and cared for overall.
Trailer
- Check tires for age, cracking and wear.
- Bearings: jack up each wheel if possible, check for play, and spin it to listen for grinding.
- Test the brakes, if fitted, and look for rust on brake components.
- Inspect the frame, bunks or rollers, winch, strap, safety chains, lights and wiring.
- Confirm the trailer title or registration is in order.
Sea trial checklist
Don’t buy a used wake boat without running it. During the sea trial:
- Warm-up: the idle is smooth, and there are no alarms or warning lights.
- Temperature and oil pressure gauges are stable and in normal ranges.
- Acceleration: the boat gets on plane without hesitation or bogging.
- Wide-open throttle: the engine reaches the RPM range the manufacturer specifies, smoothly.
- Shifting: forward, neutral and reverse engage cleanly, without loud clunks.
- Steering and tracking: the boat drives straight, with no odd vibration.
- Speed control: set a speed and see whether it holds it.
- Ballast and surf system: fill, set up a wave, switch sides, then drain.
- After the run: recheck the bilge for water and the engine bay for leaks.
Questions to ask the seller
- How many owners has the boat had, and how long have you owned it?
- Where was it stored? Covered, indoors, or on a lift?
- Has it been used in saltwater? (See wake boats for saltwater use.)
- Has it ever overheated, sunk or been in an accident?
- When were the impeller, fluids and filters last changed?
- Who did the winterization and service work?
- Why are you selling?
Professional survey and mechanical inspection
For most wake boat purchases, a marine survey and an engine and drivetrain inspection by a qualified technician are worth the cost. A surveyor can assess structure and systems. A mechanic who knows the engine brand can check compression, read engine data and spot issues you might miss. Lenders and insurers may ask for a survey on some boats, and the report can help you negotiate.
Red flags that justify walking away
- Milky engine, transmission or V-drive fluid
- Soft floors, a soft transom or signs of rot
- Significant hull cracks or poor structural repairs
- A seller who won’t allow a sea trial or an independent inspection
- No records and high hours, or hours that don’t match the boat’s wear
- A title or HIN that doesn’t match
Once a boat passes, compare its price with similar listings using our wakeboard boat cost guide and depreciation and resale value guide. If you’re still choosing models, see the best used boats for wakesurfing.