Wakeboarding Basics

How to Ollie on a Wakeboard

Learn to ollie on a wakeboard: practicing on land, loading the tail, springing and lifting your knees, landing smoothly, common mistakes and next steps.

On this page
  1. What Is an Ollie on a Wakeboard?
  2. Why Learn It
  3. Practice on Land First
  4. How to Ollie on the Water, Step by Step
  5. Common Mistakes and Fixes
  6. Building Height
  7. Nollies and Next Steps

What Is an Ollie on a Wakeboard?

An ollie is a jump you make without a ramp, using your own legs and the flex of the board to pop off flat water. The move comes from skateboarding. You load the tail of the board, spring off it, lift your knees and bring the board up with you before landing back on the water.

On a wakeboard you can’t snap the tail against the ground the way a skateboarder does, so the pop comes from pressing the tail down into the water, letting the board flex, and springing up from it with good timing.

Why Learn It

The ollie is worth learning early because it:

  • Teaches you to get the board off the water using your legs, which helps with timing and pop on wake jumps
  • Lets you hop over small rollers, boat chop and the wake itself
  • Is a building block for surface tricks such as 180s, and for hitting obstacles at a cable park
  • Builds confidence in leaving the water and landing in control

Practice on Land First

You can rehearse the motion on dry land, without the board, before getting on the water:

  1. Stand in your riding stance, knees bent, with a partner or a fixed strap to hold like a handle.
  2. Shift your weight onto your back foot and sink slightly.
  3. Spring up off your back foot, lifting your front knee first and then your back knee toward your chest.
  4. Land softly with both feet, knees bent.

This helps you feel the sequence of load, spring and tuck. Some riders also practice on a trampoline. If you do, be careful and keep it to the basic motion.

How to Ollie on the Water, Step by Step

Start in the flat water between the wakes, at your usual riding speed.

1. Ride in a Stable Stance

Ride with the board fairly flat or on a very light heelside edge. Keep your knees bent, chest up and handle low near your front hip. A low handle keeps the rope tension steady and stops it pulling you forward when you jump.

2. Shift Weight to the Tail

Move your weight toward your back foot. You’re preparing to press the tail of the board down into the water.

3. Load and Spring

Sink lower by bending your knees, pressing down through your back foot to load the tail. Then spring upward, pushing off your back foot. The tail should push into the water and help pop the board up.

4. Lift Your Knees

As you spring, lift your front knee first, then quickly lift your back knee. Tucking both knees toward your chest brings the board up off the water with you. If you just straighten your legs, the board tends to stay on the surface.

5. Level Out and Land

At the top, the board should be roughly level beneath you. Extend your legs slightly as you come down and land with both feet at the same time, knees bent to absorb the impact. Keep the handle low and ride away.

Common Mistakes and Fixes

  • Jumping with your arms: pulling the handle up lifts your shoulders but not the board, and creates slack. Keep the handle low and let your legs do the work.
  • Not loading the tail: jumping from a flat, centered stance gives very little pop. Shift your weight back and press down before you spring.
  • Forgetting to lift the knees: the board stays on the water while your body goes up. Tuck your knees toward your chest.
  • Landing tail-heavy or nose-first: this often leads to a fall. Aim to level the board in the air and land with both feet together.
  • Stiff legs on landing: stiff legs make for a jarring landing that knocks you off balance. Keep your knees soft.
  • Looking down: this tips your weight forward. Keep your eyes up and ahead.

Building Height

Once you can get the board off the water, work on gradually bigger ollies:

  • Make the load deeper and the spring more explosive
  • Tuck your knees higher
  • Use a small roller or a little boat chop as a mini ramp to get used to more height
  • Practice ollies on both heelside and toeside, and eventually switch. Our regular vs goofy guide explains what riding switch means.

A solid edge makes all of this easier. If you’re not yet comfortable on both edges, see how to edge and carve on a wakeboard.

Nollies and Next Steps

A nollie is the same move done off the nose of the board. You load your front foot and spring off it, then lift your back knee first. It’s a useful variation and often feels quite different from a regular ollie.

Once your ollies are consistent, you’re ready to:

  • Ollie over the wake from outside it, as a first step toward jumping
  • Learn how to jump the wake with single-wake and wake-to-wake jumps
  • Try surface spins, such as a basic 180, which use a small ollie to free the board from the water

For the full beginner path from the deep-water start onward, see our guide to wakeboarding behind a boat.

The complete guide to wakeboarding basics

How to Wakeboard Behind a Boat: A Beginner's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →

How Wake Boats Work

How wake boats turn weight, hull shape, speed and surf systems into rideable wakes and waves, plus a plain-English tour of the parts of a wakeboard boat.